Plasma etching

The plasma etching area is made up of:

- 6 high density plasma etching devices (RIE-ICP) in order to process 4-inch wafers.
- 2 devices for removing organic polymer (resist) and surface treatment (fictionalization).

Every RIE-ICP devices have two RF generators (13.56MHz) allowing to control plasma density (RF source) and radicals energy (RF platen).
The process pressure is controlled during process by a butterfly valve and turbomolecular pumping.
RIE-ICP allows to investigate a lot of physic-chemical etching process (ICP and CCP mode).

The STS (multiplex) equipment allows the silicon deep etching by Bosch process.

The 3 Aviza Technology machines (Omega 201) allow to process batches of 25 wafers (6-inch). Materials etched are silicon (oxide, nitride…), III-V materials and materials used for micro and nanotechnology.

The Alcatel (AMS4200) equipment contains 2 reactors, one for the deep etching silicon by tri-pulsed process, and the other for dielectric materials (etching like glass, fused silica, quartz) by continuous etching process.

The Diener (nano) equipment allows the oxygen treatment of materials used for MOS technology.

The etching monitoring is made by optical end point detection systems:
- LEPD: Laser End Point Detection
- OES: Optical Emission Spectroscopy. This system multi wavelength can control the reactor cleanliness.
- probe Zscan: Impedance detection of etching plasma allows etching monitoring and control the reactor cleanliness.
LEPD and OES detections systems can be installed on all etching equipments.




      

Equipments

STS Multiplex


DRIE
Aviza Technology Omega 201

 


 

Aviza Technology Omega 201










Aviza Technology Omega 201







Tepla 300









Diener nano



ClusterAMS4200 :
Si reactor
Silica reactor

Detection tools
Z scan probe :
End point detection by plasma impedance:

Reflectometry (Intellemetrix ) :
End point detection by Laser reflectrometry 670nm

Plasmascope (Horiba Jobin Yvon) :
End point detection and control the reactor cleanliness by OES (Optical Emission Spectroscopy) :
Gamme 190nm-870nm


Know How



Bosch process (STS) for the achievement of micrometrical silicon etching with vertical sidewalls



Tripulse (Alcatel) process for the vias etching achievement



Etching process with high aspect ratio for the silicon pillar realization



Standard process with CHF3 chemical for the multi-layers etching (poly-Si, SiNx, SiO2)



VCSEL structures after etching
 

Chloride etching process for the 2D photonics crystals in GaAlAs/GaA realization